Description
The 206 motor requires 7 GPM (26.5 LPM) maximum hydraulic fluid input and fits virtually all tractor hydraulic systems. Recommended for:
- Pressure Compensating Closed Center Systems
- Load Sensing Closed Center Systems
- Open Center Systems up to 16 GPM (60.6 LPM) using internal needle valve bypass
- Integral Needle Valve bypasses up to 9 GPM on Open Center Systems
- Standard with Viton Carbon/Ceramic Mechanical Seal
- Chemical Resistant Valox Impeller
- Cast Iron Pump
- Stainless Steel Shaft and Wear Ring
FMC HYD Series
- Suction : 1-1/4"
- Discharge : 1"
- Maximum Gallons Per Minute - 85 GPM
- Maximum PSI - 100 PSI
- Do Not Run Dry - Seal damage will result from running dry. Impeller damage may also occur if run dry for an extended period.
